PowerBridge Solution for HDTV is the most cost effective In-Wall Electrical Solution to protect expensive Home Theater HDTV equipment from surge damage and the best solution to provide clean A/C power when connected to a Power Surge/Conditioner.

Allows all connected Home Theater HDTV components on the same A/C electrical circuit, reducing interference and line noise from separate household A/C circuits and outlets.

PowerBridge is ETL tested and certified
Easy to Install

At the same time in routing the A/V cables between the HDTV and source equipment, running NM (non-metallic) type electrical wire, also known as ROMEX®, between the POWER INLET and POWER OUTLET and making simple secure screw connections on the back of each wall plate.
Kit does not include NM type wire-ROMEX® ; very inexpensive and can be purchased at most hardware and home supply stores by the foot or in 12', 25', 50' boxes, or larger reels.
NOTE: Some areas, local jurisdictions, may require using metal electrical boxes and jacketed metal electrical wire. It is advised to check with your specific local building jurisdiction as to any special code requirements. Metal boxes are not included, or optional with the PowerBridge kit, however the plate will fit within metal and new-work electrical boxes.

The PowerBridge™ kit comes with easy to follow instructions, with pictures, and wall cut-out template for the 2 Carlon® in-wall electrical boxes for retro-fit into the drywall. All you need is a drywall saw or sharp utility knife, and a screwdriver to install the electrical boxes.

PowerBridge Solution for HDTV can be installed vertically or horizontally, to assure concealment behind the HDTV and alignment around the TV wall mount.

 Safe to Install
PowerBridge Solution for HDTV is designed as a plug-in electrical device to an existing grounded A/C outlet or surge protector.

During installation, there is never any direct contact with electricity or live electrical circuits.
NO direct wire branching of electrical wiring to, or, from the electrical circuit, back of an existing outlet or house power panel. Direct wired only between the POWER INLET and POWER OUTLET wall plates.

After the wall plates are installed, the POWER OUTLET receptacle is energized by simply plugging in the supplied 36" PowerCord female end to the POWER INLET and the male end to the A/C power source, such as a surge protector or nearby existing A/C outlet.

    There are no products in this category.