Standards: IEEE 802.3u 100Base-FX/TX, IEEE 802.3 10Base-T
Bus Architecture: 32-Bit PCI
Connector: Multi-Mode Duplex-ST, 1310nm & RJ-45
Fiber port and TP port CANNOT BE USED SIMULTANEOUSLY,
i.e. use one connector at a time. Best way to switch between them
is to power down your system first, then select the desired connector.
Supports PXE ROM (P/N #: PXEROM1X50, comes with MBA Utility)
Data Transfer Rate: 100Mbps for FX, 10/100Mbps (auto-negotiation) for TX
Duplex Mode: Full or Half (device driver selectable) for FX
Full or Half (auto-sense) for TX
Cables/Max length: 50/125, 62.5/125, 100/140µm Multi-Mode fiber, up to 2km
9/125µm Single-Mode fiber, from 20 to 60km (model dependent)
Category 5 or up UTP cable for 100Mbps, up to 100m
Category 3 or up UTP cable for 10Mbps, up to 100m
LEDs: LinK/ACT, FDX
Power Requirement: 1.0A@+5V
Operating Temperature: 0° to 50° C
Humidity: 5% to 90%
Dimension: 62 x 147mm (H x W)
Bracket:AFP2100SC/ST/MT/SC20/SC60/BD3.20/BD5.20 — Standard Profile bracket

$specifications