TECHNICAL SPECIFICATIONS
* Model:
AFP2100SC / AFP2100ST / AFP2100MT
AFP2100SC20 / AFP2100SC60 / AFP2100BD3.20 / AFP2100BD5.20
AFP2100LSC / AFP2100LST / AFP2100LMT
AFP2100LSC20 / AFP2100LSC60 / AFP2100LBD3.20 / AFP2100LBD5.20
* Standard: IEEE 802.3u 100Base-FX/TX, IEEE 802.3 10Base-T
* Bus Architecture: 32-Bit PCI
* Connectors:
AFP2100SC/LSC — Multi-Mode Duplex-SC, 1310nm & RJ-45
AFP2100ST/LST — Multi-Mode Duplex-ST, 1310nm & RJ-45
AFP2100MT/LMT — Multi-Mode MT-RJ, 1310nm & RJ-45
AFP2100SC20/LSC20 — Single-Mode Duplex-SC/20km, & RJ-45
AFP2100SC60/LSC60 — Single-Mode Duplex-SC/60km, & RJ-45
AFP2100BD3.20/LBD3.20 — Single-Mode Simplex-SC/20km, TX 1310nm & RJ-45
AFP2100BD5.20/LBD5.20 — Single-Mode Simplex-SC/20km, TX 1550nm & RJ-45
* Note: Fiber port and TP port CANNOT BE USED SIMULTANEOUSLY,
i.e. use one connector at a time. Best way to switch between them
is to power down your system first, then select the desired connector.
* Data Transfer Rate: 100Mbps for FX, 10/100Mbps (auto-
negotiation) for TX
* Duplex Mode:
Full or Half (device driver selectable) for FX
Full or Half (auto-sense) for TX
* Cable / Max Distance:
50/125, 62.5/125, 100/140µm Multi-Mode fiber, up to 2km
9/125µm Single-Mode fiber, from 20 to 60km (model dependent)
Category 5 or up UTP cable for 100Mbps, up to 100m
Category 3 or up UTP cable for 10Mbps, up to 100m
* LEDs: LinK/ACT, FDX
* Power Requirement: 1.0A@+5V
* Operating Temperature: 0° to 50° C
* Humidity: 5% to 90%
* Dimension: 62 x 147mm (H x W)
* Bracket:
AFP2100SC/ST/MT/SC20/SC60/BD3.20/BD5.20 — Standard Profile bracket
AFP2100LSC/LST/LMT/LSC20/LSC60/LBD3.20/LBD5.20 — Low Profile bracket
* Safety: FCC Class A, CE Mark Approval, RoHS Compliance
DEVICE DRIVERS
* Microsoft Windows 95OSR2/98/98SE/ME/NT4.0/2000/XP
* Novell NetWare Server 3.12/4.0/4.0/4.1x/5.0
* Novell NetWare DOS ODI Client
* Packet Driver
* Linux (No technical support provided)