For flawless transmission, the output of the cable is placed at the end of the display to amplify full signal transmission with zero signal loss. The built-in booster does not require an external power, since it is using the 5-volt from pin 18 on the HDMI cable extracting the power from the display. These cables are fully CL3 certified which surpasses any in-wall code requirement for residential or commercial installations.

• High Speed HDMI cables with Ethernet
• Built-in booster for active signal amplification
• 8–levels of selectable equalization
• 3D and 4Kx2K support (4-times the resolution of 1080p)
• Compatible with prior versions of HDMI and DVI
• Data rates up to 10.2 Gbps
• Support color depths to 48 bits
• Up to 100 Mbps of bi-directional (full-duplex) bandwidth is accessible over the HDMI Ethernet Channel
• HDCP compliant
• No external power required
• Available in lengths of 25 feet, 50 feet, 75 feet and 100 feet

System Management Bus (SMBus): provides control of boost, output amplitude, enable, and clock channel signal detect threshold

Data rates: Up to 10.2 Gbps

Color Depth Support: 30 bit, 36 bit and 48 bits (16 bits per color)

Vertical Frequency: Supports 60Hz & 120Hz DC-Coupled inputs and outputs

Regulatory Compliance: RoHs compliant and CL3 rated

Temperature: -40°C to +85°C operating range

Shielding & Protection:

• Triple-layer shielding for EMI/RFI rejection
• 24 AWG copper wire construction

Dimensions:

• HDMI Cable Diameter: 0.37" (9.5mm)
• HDMI Connector: 0.55" H x 0.8"W x 1.5"L
• Built-in Signal Repeater: 0.6"H x 1.00"W x 3.1"L

Warranty: Full 1-Year parts and labor

*NOTICE*

Side labeled "Input" should be connected to the source. Side labeled "Output" should be connected to the sink (display).