The KanexPro Long-Runner employs HDBaseT technology to route high-resolution HDMI signals from the source up to 330 feet (100m) to your HD display. It supports full 3D with resolutions up to 4Kx2K (4 times the 1080p), multi-channel audio and IR extension over a single low cost CAT5e/6 cable.

Fully compliant with HDCP, EDID and CEC controls, the Long-runner HDMI extender is an ideal solution for HDMI extension over long distances.

Please note:

To reduce video dropout problems from lightings, ceiling fans and other EMI issues, it is strongly recommended that you terminate shielded CAT5e/CAT6 and use shielded RJ45 connectors with our extender products. "EZ end" connectors are not recommended for use with HDMI extenders.

• Extend HDMI signals up to 330 ft. (100m) on single CAT6 cable
• Infrared Signal Input/Output, embedded over extension
• Supports resolutions from 1080p/60@48bit to 4Kx2K
• Supports data rates up to 10.2 Gbps
• Enables 3D pass-through
• Supports CEC pass-through
• HDCP and EDID compliant
• Audio support: Dolby TrueHD & DTS Master Audio, 7.1 compliant
• Uncompressed audio support such as LPCM
• Front panel-LEDs for link activity and HDCP authentication
• External power supplies included

Note: Please adhere to the TIA/EIA568B standards when terminating network cables in the field.

Interface:

• Transmitter:
  • Input: HDMI
  • Output: HDBaseT (Cat 5e/6)
• Receiver:
  • Input: HDBaseT (Cat 5e/6)
  • Output: HDMI

Video Amplifier Bandwidth: 6.75Gbps / 2.25Gbps per channel

Vertical Frequency Range: 50/60Hz

Resolutions (HDTV): 480i, 576i, 480p, 576p, 720p, 1080i, 1080p

Computer Resolution: WUXGA (1920x1200)

Power: 5V DC@2A

Power Consumption: 5W (Maximum)

Regulatory Approvals Converter: FCC, CE, UL

Regulatory Approvals Power Supply: FCC, CE, UL

Dimensions: 3.93”x2.5”xZ1.0” (100x65x25.5mm)

Weight: 0.37 lbs. (170g)

Warranty: 1 Year limited

Helpful Tips & Recommendations:

• CAT-5 cables should not exceed 330 feet or (100m).
• Please adhere to the TIA/EIA568B standards when terminating network cables in the field.
• Shielded CAT5/6 with metal RJ-45 connectors are recommended to safeguard against random video flashes caused by electromagnetic interference (EMI).
• Do not use crossover cables, patch cables or Ethernet couplers to extend two CAT5 cables. This may damage the Tx & Rx.
• If the power LED indicator on the Tx/Rx unit is not on, check to make sure that the CAT5 cables are not crossed i.e., Ethernet to Link instead of Ethernet to Ethernet.