Cat5 TX - Transmitter
Distribute High Definition Component Video with Digital or Stereo Audio or Composite Video and Digital or Stereo Audio over extended distances with CAT5 Cable.

   •Active amplification ensures high quality transmission
   •Discrete passive IR channel for the use of external IR remote control systems
   •Loop output for use of additional CAT5 transmitters
   •Two CAT5 outputs for additional location

Works with Receiver part number CAT5RX

   •Cable Length equalizer for long distances
   •Video continuity LEDs to ensure all signals are transmitting
   •IR output

Specifications:
Video
Nominal Input Level: 1 Volt peak to peak
Gain: 1 Volt into 75 Ohms (2 volts Unterminated)
Input Impedance: 75 Ohms
Output Impedance: 75 Ohms
Isolation port to port: >65 dB
Isolation out to input: >80 dB
Return loss: >30dB
Video Bandwidth: >50MHz (HDTV requires 37 MHz min.)
Distance: 300 feet@1080i (500 feet with CAT6 cable).
3 Composite video signals may be substituted for Component Video inputs (1000 Ft. max).

Audio (Analog)
Nominal Input Level: 1 Volt peak to peak
Gain: Unity (slightly reduced at max cable length)
Input Impedance: 22k ohm
Frequency Response : 20 Hz to 20 kHz
Signal to Noise: 80 dB @ 1 Volts out

Audio (Digital)
Supports standard SPDIF digital audio.
(Port can support optional Composite Video)

Power
Requirement: External 9 or 10 Volt AC @ 600 mA with a (2.1 mm center) Coaxial connector.

Note: Composite Video may be used for video security or with standard video monitors

$specifications