As prices for IP cameras continue to drop and the quality
continues to rise, there is an increase in the number of IP camera
installations in many types of facilities which already have
installed coax. ETS now has a way to utilize the existing coax
cable by installing a pair of low cost ETS IP Camera Baluns
(EIP-XX Series)…a technology unique to ETS.

Using installed coax with ETS IP Camera Baluns can be used as a
permanent installation solution or as a stop-gap measure until
later upgrades are made. One run of coax cable replaces two pair
UTP with improved NEXT (near-end crosstalk) over the 802.3
specification.

Most existing installations for CCTV cameras use 75 ohm RG59 coax or
similar cable.
A variety of configurations are available to meet your specific IP
camera connectivity requirements.

Features:
• Low cost speedy installation using legacy cable
• Exceeds 802.3 10BaseT NEXT specification, isolating the receiver
from the transmitted signal
• Passive unit (no power required)
• Run over 200 meters on coax.
• Impedance matched
• Rugged compact case

Applications:
Any facility wired with legacy cable can add an IP camera to existing
coax installations in:
• Airports
• Banks
• Casinos
• Hotels
• Hospitals
• Schools
• Parking lots
• Residences
• Corporations

Specifications:
Insertion Loss
<0.5 dB

Connectors
BNC or F Connector to RJ45 Jack

Impedance
50Ω to dual 100Ω or 75Ω to dual 100Ω or 93Ω to dual 100Ω

Crosstalk
> 30 dB

Dimensions
56mm x 19mm x 21mm
(L x W x H)

Net Weight
0.02 kg (approximate)

Ordering parts#:
EIP-XX-F-45
Female F Connector to RJ45 jack

EIP-XX-FBNC-45
Female BNC to RJ45 jack

EIP-XX-MBNC-45
Male BNC to RJ45 jack

xx = 58, 59, 62 for wiring of 50, 75 or 93Ω coax, respectively
All Pin-outs: Standard Ethernet pin-outs (1,2 & 3,6)