The KanexPro High Speed HDMI cables with Ethernet are designed with built-in booster for applications that require high-performance transmission of HDMI digital video and multi-channel audio signals. These cables have active amplification built-in to prevent impedance mismatch, caused by the cable attenuation, dielectric losses and compensation for skin effect over long distances.

For flawless transmission, the output of the cable is placed at the end of the display to amplify full signal transmission with zero signal loss. The built-in booster does not require an external power, since it is using the 5-volt from pin 18 on the HDMI cable extracting the power from the display. These cables are fully CL3 certified which surpasses any in-wall code requirement for residential or commercial installations.

• High Speed HDMI cables with Ethernet
• Built-in booster for active signal amplification & equalization
• 8–levels of selectable equalization
• 3D and 4Kx2K support (4-times the resolution of 1080p)
• Compatible with prior versions of HDMI and DVI
• Data rates up to 10.2 Gbps
• Support color depths to 48 bits
• Up to 100 Mbps of bi-directional (full-duplex) bandwidth is accessible over the HDMI Ethernet Channel
• HDCP compliant
• No external power required
• Available in lengths of 25 feet, 50 feet, 75 feet and 100 feet

Standards: High speed HDMI cable with Ethernet

System Management Bus (SMBus): provides control of boost, output amplitude, enable, and clock channel signal detect threshold

Data rates: Up to 10.2 Gbps

Color Depth Support: 30 bit, 36 bit and 48 bits (16 bits per color)

Vertical Frequency: Supports 60Hz & 120Hz DC-Coupled inputs and outputs

Regulatory Compliance: RoHs compliant and CL3 rated

Temperature: -40°C to +85°C operating range

Shielding & Protection:

• Triple-layer shielding for EMI/RFI rejection
• 24 AWG copper wire construction

Dimensions:

• HDMI Cable Diameter: 0.37" (9.5mm)
• HDMI Connector: 0.55" H x 0.8"W x 1.5"L
• Built-in Signal Repeater: 0.6"H x 1.00"W x 3.1"L

Warranty: Full 1-Year parts and labor

*NOTICE*

Side labeled "Input" should be connected to the source. Side labeled "Output" should be connected to the sink (display).